Eastwood Bead Roller Metal Fabrication Forming Dies

This kit includes an additional 10 dies to use with any bead roller with a 22mm shaft. While most metal bead rollers come with basic dies, some enthusiasts want to go beyond these options for their custom creations. With these additional dies on your bead roller you can create offset flanges, contours, deep channels, and style lines. This kit also includes a polyurethane lower “skate board” wheel, which can be used with a variety of upper dies to modify the bends. The dies includes in this kit are inside and outside offset dies, 3/8 and 1/2 inch tipping dies, round and knife edge tipping dies, 180 degree lower die, lower edge forming die and a lower forming die. All are made of CR12 steel with a Rockwell hardness of 35 HRC.

Specifications

Material: CR12
Hardness: 30-40 HRC

Contents

(1) Polyurethane Lower Wheel
(1) 180 Degree Lower Die
(1) Inside Offset Die
(1) Outside Offset Die
(1) Knife Edge Tipping Die
(1) Lower Edge Forming Die
(1) 3/8 in Tipping Die
(1) 1/2 in Tipping Die
(1) Round Tipping Die
(1) Lower Forming Die