Rust-Oleum® Acrylic Enamel 2x contains breakthrough technology that provides twice the coverage on metal, most plastic, wood, and more. This general purpose paint covers surfaces with less spray passes, allowing projects to be completed faster and easier. Any angle spray feature allows you to spray in any direction, even upside down.
Rust-Oleum Acrylic Enamel Gloss Cherry Red 12oz:
proposition 65 reasons:WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
Cancer and Reproductive Harm – www.p65warnings.ca.gov
Instructions: . Comfort spray tip with wider finger pad reduces fatigue caused by continuous spraying. Fast drying. Tip: Some plastic made of polyethylene are manufactured in a way that may hinder maximum paint adhesion. Test paint in a hidden area first. Read All Directions Before Beginning Project. Painting Conditions: Use outdoors or in a well-vetilated area such as an open garage. Use when temperature is between 50°F (10°C) and 90°F (32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy, dusty conditions. Cover surrounding area to protect from spray mist. Preparation: Remove loose paint and rust with wire brush or sandpaper. Lightly sand glossy surfaces. Clean with soap and water, rinse and let dry. Priming: Use of Rust-Oleum® primer provides superior adhesion and is especially recommended for bare metal and wood. Painting: Shake can vigorously for one minute after mixing ball begins to rattle. If mixing ball fails to rattle, Do Not Strike Can. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart. Dry & Recoat Times based on 70°F - 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 20 minutes, to handle in 1 hour and fully dry in 24 hours. Apply a second coat or Clear coat within 1 hour or after 48 hours. Apply clear in 2-3 light coats a few minutes apart. Note: On plastic maximum paint adhesion and durability is achieved in 5-7 days. Clean-up: Wipe off tip before storing. Clean up wet paint with Xytol or mineral spirits. Throw away empty can in trash pickup. Do not burn or place in home trash compactor. Clogging: If valve clogs, twist and pull off spray tip and rinse it in a solvent such as mineral spirits. Do not stick pin or other object into the stem.
|Manufacturer Part Number|
|Assembled Product Dimensions (L x W x H)|
2.63 x 2.63 x 7.88 Inches