Instructions: To Apply: 1. Clean surface with isopropyl rubbing alcohol, wipe gently, let dry. Do not use household cleaners. Separate strips. 2. Remove red liners. Press adhesive to hook. Repeat, with second strip. 3. Black side. Remove black liners. 4. Press to surface for 10 seconds. 5. Important: For maximum holding strength slide hook off. 6. And press base firmly for 30 seconds. 7. Slide hook on. 8. Wait 1 hour before use. To Remove: 1. Slide hook up to remove from mounting base. 2. Never pull strip towards you. 3. Hold base gently to prevent base from snapping fingers. Do not press base against wall. 4. Stretch straight down along wall at least 15 inches (38 cm) until base and strip release. Note: Apply to surfaces above 50 degrees F (10 degrees C). Adhesive could lose adhesion above 105 degrees F (40 degrees C). Hook can be reused with Command Large Strips.