Rated 3.3 out of 5★ by 3reviewers.
Rated 2 out of 5★ by itemsold1 More Difficult Than I Expected I've replaced the innards of several toilets over the years and never had any trouble doing so. This Fluidmaster kit, however, was a different story. Perhaps it is just me, but I found the instructions to be at times confusing. This had never been a problem for me in the past with other brands. Too, the whole replacement process just seemed more complicated than it had ever been in the past, again with other brands. This is the first time I have used Fluidmaster; I guess it is actually supposed to be a better brand than most, but I had trouble using it...oh, and for the first time ever, after I had installed the repair kit, the toilet did not flush properly regardless of whatever troubleshooting I tried as recommended by the instructions. I"m probably going to go elsewhere and get the brand I used to use, if I can find it. 07/04/2012
Rated 3 out of 5★ by Xenophon2 Design problem I read the review from earlier in 2012 but the only repair kit Walmart had in stock was Fluidmaster, so I bought it anyway. I also had a problem but I was able to isolate the problem and find a work-around. I was getting ghost flushing and I could see from looking at the surface of the water in the bowl that there was water slowly flowing into the bowl even when the toilet was not flushing. When I reduced the water level in the tank to below the level of the flapper the flow still continued. I found that the problem was that the shank washer that seals the bottom of the housing that the flapper sits on to the inside-bottom surface of the tank was not thick enough. I sprayed the surface of the seal that contacts the flapper housing with automotive spray undercoating to form the equivalent of a thin gasket, let it dry somewhat and then re-assembled it. I did this to build up the effective thickness of the shank seal. When I mounted the whole flush valve assembly to the tank by tightening the shank nut I was very careful to keep the bevel of the shank seal centered in the mounting whole. This fixed the problem. 12/31/2012
Rated 5 out of 5★ by Peevman76 Great product So nice to just replace everything in one shot! I have very hard water and over the years the old parts began to break down and corrode. This took care of my leak and now I know I have bought myself a few more years of trouble free maintenance. 07/15/2014